Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| qcsmarine:nmea_notes [2022/01/10 18:31] – admin | qcsmarine:nmea_notes [2022/04/07 15:03] (current) – admin | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| {{: | {{: | ||
| + | <WRAP left round box 60%> | ||
| + | === Standard Horizon === | ||
| + | 6.5 ACCESSORY CABLE\\ | ||
| + | Wire Color/ | ||
| + | WHITE - External Speaker (+) Connect to external 4 Ohm audio speaker\\ | ||
| + | SHIELD - External Speaker (–) Connect to external 4 Ohm audio speaker\\ | ||
| + | BLUE - NMEA GPS Input (+) Connect to NMEA (+) output of GPS\\ | ||
| + | GREEN - NMEA GPS Input (–) Connect to NMEA (–) output or common ground of GPS\\ | ||
| + | GRAY - NMEA DSC Output (+) Connect to NMEA (+) input of GPS\\ | ||
| + | BROWN - NMEA GPS Output (–) Connect to NMEA (–) input of GPS\\ | ||
| + | : Some GPS chart plotters have a single wire for NMEA signal ground. In such a case | ||
| + | connect the NMEA input (–) to the GPS chart plotter’s single NMEA signal ground wire, and | ||
| + | leave the NMEA output (–) open. In case the assignment of power supply and ground of a | ||
| + | GPS chart plotter to be used is different from that of the radio, connect the signal ground | ||
| + | wire of the GPS chart plotter to the ground terminal (GND) on the rear panel of the radio. | ||
| + | When connecting the external speaker, chart plotter, or external GPS | ||
| + | antenna, strip off about 1 inch (2.5 cm) of the specified wire’s insulation, then | ||
| + | splice the ends together. | ||
| + | </ | ||
| + | \\ | ||
| + | <WRAP left round box 60%> | ||
| ==== UNIDEN ==== | ==== UNIDEN ==== | ||
| Line 45: | Line 66: | ||
| If the GPS receiver is correctly connected and it transmits valid data, the display shows GPS | If the GPS receiver is correctly connected and it transmits valid data, the display shows GPS | ||
| Data OK. Press ENT-1W25W to open the GPS status screen and see detailed GPS data: | Data OK. Press ENT-1W25W to open the GPS status screen and see detailed GPS data: | ||
| + | </ | ||